Storage and Space Saving Ideas in a Cape Cod Bedroom

This was a REALLY fun project. The front bedroom…. When the offspring were all out of the house and our nest was empty for the first time, I had the opportunity to redo this room from top to bottom. First of all, this is one of the best rooms in the house — very quiet and private with lots of interesting angles, and there is a view of the marsh at certain times of the year. It is, however, on the small side at 11′ x 14′. The room needed to be changed from a teen ravaged bedroom (for many years) to a guest bedroom that could sleep a couple, and still accommodate the ‘coming home for awhile’ of an offspring here and there. Because it is a small room. I wanted clean simple, and MOSTLY easy to clean fixtures and furniture that are still comfortable. I had the idea that some of the insulation had fallen down behind the knee wall because the room was always pretty cold. So, I started by cutting between the joists in the knee wall for the shelves you see here. The double shelf unit is on this wall and a single is on the other side of the dormer space.

These shelves are cut into the knee wall, framed inside the wall with 2'x 4's, insulated all around, and trimmed on the inside with 3/4' pine.

These shelves are cut into the knee wall, framed inside the wall with 2′x 4′s, insulated all around, and trimmed on the inside with 3/4′ pine.

Actually, I started by calling in the oil company rep and asked about extending the heat register in the room. Apparently, the door to the room needs to be left opened to allow the heat to circulate through the upstairs properly. Needless to say, during a decade of teenagers the door had been mostly closed. I discovered after cutting into the wall, however, that as suspected there was a piece of insulation behind the knee wall that had fallen down. There was also a hole from the outside, to accommodate a phone wire, that needed to be caulked. And! There were holes from a fallen down shelf in the closet that were blasting in the cold air.

So, I built a sort of frame system out of 2x4s for each of the shelving units that could be fitted into the holes in the wall, and built the shelf units separately from pine. The 2×4 frames were specifically built so they could be screwed into the existing framing of the house – the rafters, flooring board, and wall studs. I put insulation all around the inside of the frame and taped all the outside joints of the shelf units with Frost King tape. I regret not having taken pictures during many parts of this project.

More soon!

Leave a Reply